Jet air filter system

The pump has one job – that is to pull the water (in the case of an in-ground pool) and push it through the filter, lines and any other equipment back into the pool. Without the pump almost all of the other equipment for the pool is useless! And if that pump cannot pump water but continues running pushing air, it will overheat and burn out in a very short period of time. This is why it is very important to make sure that you do not have air in your system, and if you do to remedy it soon before it becomes a big problem!

Let’s start off with something so obvious that it could actually be easily overlooked. That is a water level that is so low that the skimmer(s) start gulping air in with the water. In general, the water should be between ½ and ¾ up the skimmer opening(s) so as not to take in any air at all from the pool! It happens more often than you would expect, actually. Easy fix – raise the water level!

Next, if your filter has a bleeder valve (usually at the top of the filter) open this while the filter and pump are running until water spits out of the valve and then close immediately. This keeps air out of the tank and allows for maximum efficiency of filtration. Keep in mind that a filter tank that is half empty (or half full of air) is only able to do half the job filtering your pool.

21.08.2003  · JET 708620B AFS-1000B 550/702/1044 CFM 3-Speed Air Filtration System with Remote and Electrostatic Pre-Filter - Shop Air Cleaners - Amazon.com

JET 708615 Air Filtration System. The 708615 includes 1x JET 708615 AFS-2000 Air Filtration System. MPN: 708615. Type: Air Filtration System. Inner pocket filter is ...

13.04.2018  · The Jet AFS-1000B, 1000 CFM Air Filtration System, 3-Speed, with Remote Control in Woodworking, Air Filtration

Foto:

Video: